LevelOne FCS-4300 - Manual (Page 73)

SMTP
Set the SMTP menu when you want to send an image via e-mail. By using Mail (SMTP) function, you can
send a mail with attached image which has been shot linked with the external sensor input or with the
built-in motion detection function. The image file can also be sent periodically. E-Mail (SMTP) setting menu
is composed of three tabs, General, Alarm sending and Periodical sending.
General
Select On when you use the SMTP function. The common setting options are displayed below. If you do
not wish to use the e-Mail (SMTP) function, select Off and click OK.
Note ：
• During transmission of an image file via mail, the frame rate and operation performance of the monitor
image of the main viewer decline.
• While the camera video mode is set to MPEG4, the image of the composite video signal output from the
video output connector of the camera may be distorted during mail transmission.
• You cannot send an audio file by using the mail sending function.
SMTP server name：Type the SMTP server name up to 64 characters, or the IP address of the SMTP
server.
Authentication：Select the authentication required when you send an email.
Off: Select if no authentication is necessary when an email is sent.
On: When authentication is necessary an e-mail is sent, select one of the authentication methods from the