LevelOne GES-2451 - Manual (Page 19)

13
Note:
The system time will be restored to the default when the switch is restarted and you need to
reconfigure the system time of the switch.
4.1.4 Daylight Saving Time
Here you can configure the Daylight Saving Time of the switch.
Choose the menu System →System Info→Daylight Saving Time to load the following page.
Figure 4-6 Daylight Saving Time
The following entries are displayed on this screen:
 DST Config
DST Status: Enable or disable the DST.
Predefined Mode: Select a predefined DST configuration.
 USA: First Sunday in April, 02:00 ~ Last Sunday in October,
02:00.
 Australia: First Sunday in October, 02:00 ~ First Sunday in
April, 03:00.
 Europe: Last Sunday in March, 01:00 ~ Last Sunday in
October, 01:00.
 New Zealand: First Sunday in October, 02:00 ~ Last Sunday in
March, 03:00.
Recurring Mode: Specify the DST configuration in recurring mode. This
configuration is recurring in use.
 Offset: Specify the time adding in minutes when Daylight
Saving Time comes.
 Start/End Time: Select starting time and ending time of Daylight
Saving Time.