LevelOne GES-2451 - Manual (Page 20)

14
Date Mode: Specify the DST configuration in Date mode. This configuration is
one-off in use.
 Offset: Specify the time adding in minutes when Daylight
Saving Time comes.
 Start/End Time: Select starting time and ending time of Daylight
Saving Time.
Note:
1. When the DST is disabled, the predefined mode, recurring mode and date mode cannot be
configured.
2. When the DST is enabled, the default daylight saving time is of Europe in predefined mode.
4.1.5 System IP
Each device in the network possesses a unique IP Address. You can log on to the Web
management page to operate the switch using this IP Address. The switch supports three modes
to obtain an IP address: Static IP, DHCP and BOOTP. The IP address obtained using a new mode
will replace the original IP address. On this page you can configure the system IP of the switch.
Choose the menu System →System Info→System IP to load the following page.
Figure 4-7 System IP
The following entries are displayed on this screen:
 IP Config
MAC Address: Displays MAC Address of the switch.
IP Address Mode: Select the mode to obtain IP Address for the switch.
 Static IP: When this option is selected, you should enter IP
Address, Subnet Mask and Default Gateway manually.
 DHCP: When this option is selected, the switch will obtain
network parameters from the DHCP Server.
 BOOTP: When this option is selected, the switch will obtain
network parameters from the BOOTP Server.