LevelOne WHG-1000 - Manual (Page 26)

WHG-1000 300Mbps Wireless PoE Hotspot Gateway
User's Manual
26
 My WAN IP Netmask : The Subnet mask of the WAN port
 MTU : By default, it’s 1460 bytes. MTU stands for Maximum Transmission Unit. Consult with WISP for a
correct MTU setting.
 MPPE Encryption : Microsoft Point-to-Point Encryption (MPPE) encrypts data in Point-to-Point Protocol(PPP)-
based dial-up connections or Point-to-Point Tunneling Protocol (PPTP) virtual private network (VPN) connections.
128-bit key (strong) and 40-bit key (standard) MPPE encryption schemes are supported. MPPE provides data
security for the PPTP connection that is between the VPN client and the VPN server.
 DNS : Check “No Default DNS Server” or “Specify DNS Server IP” radial button as desired to set up system
DNS.
 Primary : The IP address of the primary DNS server.
 Secondary : The IP address of the secondary DNS server.
 MAC Clone : The MAC address is a 12-digit HEX code uniquely assigned to hardware as identification. Some
ISPs require you to register a MAC address in order to access to Internet. If not, you could use default MAC or
clone MAC from a PC.
 Keep Default MAC Address : Keep the default MAC address of WAN port on the system.
 Clone MAC Address : If you want to clone the MAC address of the PC, then click the Clone MAC Address
button. The system will automatically detect your PC's MAC address.
The Clone MAC Address field will display MAC address of the PC connected to system. Click Save button
can make clone MAC effective.
 Manual MAC Address : Enter the MAC address registered with your ISP.
Change these settings as described here and click Save button to save your changes. Click Reboot button to
activate your changes