LevelOne WHG-1000 User Manual
Page 36
WHG-1000 300Mbps Wireless PoE Hotspot Gateway
User's Manual
36
Tx Power : You can adjust the output power of the system to get the appropriate coverage for your wireless
network. Select LEVEL 1 to LEVEL 7 needed for your environment. If you are not sure of which setting to
choose, then keep the default setting, LEVEL 7.
When Band Mode select in 802.11b/g/n or 802.11n, the HT Physical Mode settings should be show immediately.
Tx/Rx Stream : By default, it's 2.
Channel Bandwidth : The "20/40” MHz option is usually best. The other option is available for special
circumstances.
Extension Channel : Only for Channel Bandwidth “40” MHz. Select the desired channel bonding for control.
MCS : This parameter represents transmission rate. By default (Auto) the fastest possible transmission rate will
be selected. You have the option of selecting the speed if necessary.
Shout GI : Short Guard Interval, by default, it's “Enable”. it's can increase throughput. However, it can also
increase error rate in some installations, due to increased sensitivity to radio-frequency reflections. Select the
option that works best for your installation.
Aggregation : By default, it's “Enable”. To “Disable” to deactivated Aggregation.
A part of the 802.11n standard (or draft-standard). It allows sending multiple frames per single access to the medium
by combining frames together into one larger frame. It creates the larger frame by combining smaller frames with
the same physical source and destination end points and traffic class (i.e. QoS) into one large frame with a common
MAC header.
Aggregation Frames : The Aggregation Frames is in the range of 2~64, default is 32. It determines the
number of frames combined on the new larger frame.
Aggregation Size : The Aggregation Size is in the range of 1024~65535, default is 50000. It determines the
size (in Bytes) of the larger frame.
Change these settings as described here and click Save button to save your changes. Click Reboot button to
activate your changes. The items in this page is for AP's RF general settings and will be applied to all VAPs and
WDS Link.