Superwinch H14P – 6,350 kgs Manual Clutch (Long Drum) - Manual (Page 9)

ROPE INSTALLATION
The rope must be of good quality, have a steel core and meet the following specification :
1. Unwind the rope by rolling it out along the ground with the tapered end nearest to the winch. NEVER wind the rope
straight onto the drum from a coil.
2. Dis-engage the Freespool.
3. Insert the tapered end of the rope into the cross-hole in the end of the drum and secure by tightening the setscrew.
4. Re-engage the Freespool.
5. Carefully run the winch in the "Winch In" direction. Keeping tension on the rope spool 5 or 6 wraps of rope neatly
onto the drum.
6. Apply moderate tension (approx. 700 kg to the rope. Carefully run the winch in the "Winch In" direction. Ensure the
layers are neatly wrapped onto the drum. This will minimize damage to the lower layers of rope when a load is applied.
PULLING OUT THE ROPE
Disengage the Freespool. With a pair of gloves on, pull out the rope and secure to anchor or load, check that there are
at least 5 turns left on the Drum. Re-engage the Freespool.
Model Designation .................................................. H10P H12P H14P
Part No .................................................................... 5310, 5310S 5320, 5320S 5330, 5330S
............... 5311, 5311S 5321, 5321S 5331, 5331S
......... 5312, 5312S 5322, 5322S 5332, 5332S
.... 5313, 5313S 5323, 5323S 5333, 5333S
Model Designation .................................................. H14P
Part No .................................................................... 653001
Minimum Breaking Load ......................................... 84.4 kN 100.0 kN 118.0 kN
Tensile Grade ......................................................... 1960 N/mm 2 1960 N/mm 2 1960 N/mm 2
Diameter ......................................................... 11 mm 12 mm 13 mm
ROPE INSTALLATION
05
05-1 ROPE INSTALLATION