Accton Technology ES4710BD - Manual (Page 159)

158
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
7.2 Port Configuration
7.2.1 Network Port Configuration
7.2.1.1 Network Port Configuration Task Sequence
1. Enter the network port configuration mode
2. Configure the properties for the network ports
（ 1） Configure combo mode for combo ports
（ 2） Enable/Disable ports
（ 3） Configure port names
（ 4） Configure port cable types
（ 5） Configure port speed and duplex mode
（ 6） Configure bandwidth control
（ 7） Configure traffic control
（ 8） Enable/Disable port loopback function
（ 9） Configure broadcast storm control function for the switch
1. Enter the Ethernet port configuration mode
2. Configure the properties for the Ethernet ports
Command Explanation
Interface Mode
combo-forced-mode { copper-forced |
copper-preferred-auto | sfp-forced |
sfp-preferred-auto }
no combo-forced-mode
Sets the combo port mode (combo ports only);
the “no combo-forced-mode” command
restores the default combo mode for combo
ports, i.e., fiber ports first.
shutdown
no shutdown
Enables/Disables specified ports
name <string>
no name
Names or cancels the name of specified ports
mdi { auto | across | normal }
no mdi
Sets the cable type for the specified port (This
command is not supported on the ES4710BD
line card ports of 1000MB and above)
Command Explanation
Interface Mode
interface ethernet <interface-list> Enters the network port configuration mode.