Accton Technology ES4710BD - Manual (Page 167)

166
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
2. Configure the IP address for VLAN interface and enables VLAN interface.
Command Explanation
VLAN Mode
ip address <ip-address> <mask> [secondary]
no ip address [<ip-address> <mask>]
Configures the VLAN interface IP
address; the “no ip address
[<ip-address> <mask>]”
command deletes the VLAN
interface IP address.
VLAN Mode
Shutdown
no shutdown
Enables/Disables VLAN interface
7.2.2.2 VLAN Interface Configuration Commands
7.2.2.2.1 interface vlan
Command: interface vlan <vlan-id>
no interface vlan <vlan-id>
Function: Enters VLAN Interface Mode; the “no interface vlan <vlan-id>” command deletes
existing VLAN interface. .
Parameters: <vlan-id> is the VLAN ID for the establish VLAN, the valid range is 1 to 4094.
Command mode: Global Mode
Usage Guide: Before setting a VLAN interface, the existence of the VLAN must be verified. Run
the exit command to exit the VLAN Mode to Global Mode.
Example: Entering into the VLAN Interface Mode for VLAN1.
Switch(Config)#interface vlan 1
Switch(Config-If-Vlan1)#
7.2.2.2.2 ip address
Command: ip address <ip-address> <mask> [secondary]
no ip address [<ip-address> <mask>] [secondary]
Function: Sets the IP address and mask for the switch; the “no ip address [<ip-address> <mask>]”
command deletes the specified IP address setting.
Command Explanation
Global Mode
interface vlan <vlan-id>
no interface vlan <vlan-id>
Enters VLAN Interface Mode; the “no
interface vlan <vlan-id>” command
deletes specified VLAN interface. .