Accton Technology ES4710BD - Manual (Page 443)

442
E ES4710BD 10 Slots L2/L3/L4 Chassis Switch
cost Cost value
State Status
Type
Layer 3 switch type, such as designated
Priority Configure the priority in electing designated layer
3 switch.
Transit Delay The delay value for interface to transfer LAS
DR The designated layer 3 switch
BDR Backup designated layer 3 switch
Authentication key OSPF packet authentication key
Timer：
Hello, Poll, Dead, Retrans OSPF protocol timer: including time set for
HELLO packet, poll interval packet, route
invalid, route retransmission, etc.
Number of Neigbors The number of neighboring layer 3 switches
Nubmer of Adjacencies The number of neighboring route interfaces
Adjacencies Neighboring interface IP address
（
7）show ip ospf neighbor
The “show ip ospf neighbor” command can be used to display information about the neighbor OSPF
layer 3 switches.
For example, displayed information can be:
Switch#show ip ospf neighbor
interface ip 12.1.1.1 area id 0
router id 12.1.1.2 router ip addr 12.1.1.2
state NFULL priority 1
DR 12.1.1.2 BDR 12.1.1.1
last hello 66261 last exch 65712
interface ip 30.1.1.1 area id 0
interface ip 50.1.1.1 area id 0
router id 50.1.1.2 router ip addr 50.1.1.2
state NFULL priority 0
DR 50.1.1.1 BDR 0.0.0.0
last hello 66286 last exch 49614
interface ip 51.1.1.1 area id 0
interface ip 52.1.1.1 area id 0
interface ip 100.1.1.1 area id 0
interface ip 110.1.1.1 area id 0
interface ip 150.1.1.1 area id 0
router id 12.2.0.0 router ip addr 150.1.1.2
state NFULL priority 0
DR 150.1.1.1 BDR 0.0.0.0
last hello 66289 last exch 49607
Displayed information
Explanation
interface ip The IP address of an interface in the current
layer 3 switch