Teledyne LeCroy LabMaster 10Zi Getting Started Manual - Manual (Page 138)

Getting Started Manual
LM10Zi-GSM-E Rev A 131
Measurements
Measurement Parameters Overview
Parameters are measurement tools that determine a wide range of
waveform properties. Use them to automatically calculate many
attributes of your waveform, like rise-time, rms voltage, and peak-to-
peak voltage, for example.
There are parameter modes for the amplitude and time domains,
custom parameter groups, and parameters for pass and fail testing. You
can make common measurements on one or more waveforms.
Turning On Parameters
1. Touch Measure → Measure Setup... on the menu bar.
2. Touch the On checkbox for each parameter you want to enable.
3. Touch the Show Table checkbox to display the parameters below
the grid.
Quick Access to Parameter Setup Dialogs
You can quickly gain access to a parameter setup dialog by touching the
parameter list box below the grid.
For example, touch within P1 below the grid (previous) to display the P1
setup dialog.