Teledyne LeCroy LabMaster 10Zi Getting Started Manual - Manual (Page 157)

LabMaster 10 Zi Oscilloscopes
150 LM10Zi-GSM-E Rev A
When you have each of the Qx dialogs configured and enabled as
desired, you can then begin your testing and turn them all on or off
using the Testing checkbox on the main Pass/Fail dialog. You can also
specify Actions for all or some of your conditions using the Actions
dialog.
Testing and Enabling Pass/Fail Conditions
Beside each Qx button on the main Pass/Fail dialog is a corresponding
On checkbox.
Use this or the On checkbox on each respective Qx dialog to enable the
specific condition for use.
When you have each of the Qx dialogs configured and enabled as
desired, you can then turn them all on or off using the Testing checkbox
on the main Pass/Fail dialog.