Teledyne LeCroy WaveExpert 100H Operators Manual User Manual
Page 66
Operator’s Manual
64
WE-OM-E Rev A
VERTICAL SETTINGS AND CHANNEL CONTROLS
Adjusting Sensitivity and Position
To Adjust Sensitivity
1. Press the appropriate channel push button, for example
to turn on channel 1. Or
touch Vertical in the menu bar, then Channel 1 in the drop-down menu.
2. Touch
inside
the
Trace On checkbox to display the trace.
3. Turn the volts per division knob for the selected channel.
Or you can touch inside the Volts/Div field and type in a value using the pop-up keypad, or
use the up/down arrows.
4. The voltage that you set is displayed in the trace descriptor label and in the Volts/Div field.
To Adjust the Waveform's Position
Turn the vertical offset adjust knob directly above the channel button whose waveform you want to
move vertically.
Or you can touch inside the Offset field and type in a value on the pop-up keypad. To set the
vertical offset to zero, touch the Zero Offset button directly below the Offset field.