Operator’s manual – Teledyne LeCroy WaveExpert 100H Operators Manual User Manual

Page 84

Advertising
background image

Operator’s Manual

82

WE-OM-E Rev A

7. Remove the DUT from the setup to perform a calibration at the input plane of the DUT. This

is referred to as the REFERENCE PLANE, or the t=0 position. Follow the instructions on
the screen (shown in figure below) to connect each of the required precision components
(Short, 50Ω) for the calibration.

8. Once the calibration is performed, a Normalized trace (blue) is displayed on the screen.

The reference plane (t=0) is represented by a cursor line

:

Advertising
See also other documents in the category Teledyne LeCroy Equipment: