Teledyne LeCroy CP150 - Manual (Page 24)

CP150 Current Probe
18 922175-00 Rev A
CISPR 11:2003 Radiated and Conducted Emissions, Group 1, Class A, in accordance with EN61326-1:2006
and EN61326-2-1:2006.
A USTRALIA / N EW Z EALAND C ONTACTS :
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC Declaration of Conformity
– Low Voltage
The probe meets intent of EC Directive 2006/95/EC for Product Safety. Compliance was demonstrated
to the following specifications as listed in the Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 2-030: Particular requirements for testing and measuring circuits
EN 61010-031/A1:2008 Safety requirements for electrical equipment for measurement, control, and
laboratory use – Part 031: Safety requirements for hand-held probe assemblies for electrical
measurement and test.
Environmental Compliance
End-Of-Life Handling
The instrument is marked with this symbol to indicate that it complies with the applicable
European Union requirements to Directives 2002/96/EC and 2006/66/EC on Waste Electrical
and Electronic Equipment (WEEE) and Batteries.
The instrument is subject to disposal and recycling regulations that vary by country and
region. Many countries prohibit the disposal of waste electronic equipment in standard
waste receptacles. For more information about proper disposal and recycling of your
Teledyne LeCroy product, please visit teledynelecroy.com/recycle.
Restriction of Hazardous Substances (RoHS)
This instrument has been classified as Industrial Monitoring and Control Equipment, and is outside the
scope of the 2011/65/EU RoHS Directive until 22 July 2017 (per Article 4, Paragraph 3).