Teledyne LeCroy WaveLink Differential Probe Series (8-13 GHz) - Manual (Page 23)

Operator's Manual
Connecting an Amplifier Module to an Interconnect Lead
Connecting a solder-in interconnect lead to an amplifier module. The positioner tip and other leads
connect in the same manner.
Align the flat side of the lead with the flat side of the amplifier module and press together.
NOTE:
l
Although interconnect leads for the D830, D1030, and D1330 mechanically mate with any
module, they are only compatible with a Dxx30. No damage results; however, performance
may be reduced when switching leads between modules, and the response is not calibrated.
Be sure to only use leads with serial numbers that match with the differential amplifier
module.
l
Different colors indicate different bandwidths and/or product classes. Avoid accidental
interchanging by matching the color coding of the interconnect lead tip housing with the
color of the corresponding amplifier module.
Connecting the Probe to an Oscilloscope
The WL-PLINK platform/cable assembly has been designed for use with the ProLink interface of
Teledyne LeCroy's LabMaster 9 Zi-A, WaveMaster 8 Zi/Zi-A, SDA/DDA 8 Zi/Zi-A, WavePro 7 Zi/Zi-A,
SDA/DDA 7 Zi/Zi-A, and other models that use the ProLink interface.
Attach the platform/cable assembly to the ProLink interface by aligning the connector with the input
connector and pushing the interface toward the instrument.
You will hear a click when the probe interface latches to the test instrument. Tighten the
thumbscrews to secure the interface to the instrument.
Do not overtighten the thumbscrews.
924234-00 17