Teledyne LeCroy WaveLink Differential Probe Series (13-25 GHz) - Manual (Page 80)

WaveLink Series Differential Probe (13-25 GHz)
74 WL-HBW-A-OM-E Rev B
Precautions
Connect and disconnect properly. Connect probe to the measurement instrument before
connecting the test leads to a circuit/signal being tested.
Use only within operational environment listed. Do not use in wet or explosive atmospheres.
Use indoors only.
Keep product surfaces clean and dry.
Be careful with sharp tips. The tips may cause bodily injury if not handled properly.
Do not operate with suspected failures. Do not use the probe if any part is damaged. Cease
operation immediately and sequester the probe from inadvertent use.
Operating Environment
The accessory is intended for indoor use and should be operated in a clean, dry environment. Before
using this product, ensure that its operating environment is maintained within these parameters:
Temperature: 5° to 40° C.
Humidity: Maximum relative humidity 90 % for temperatures up to 31° C decreasing linearly to 50 %
relative humidity at 40° C.
Altitude: Up to 10,000 ft (3,048 m).
NOTE: Direct sunlight, radiators, and other heat sources should be taken into account when
assessing the ambient temperature.
Certifications
This section contains the instrument’s Electromagnetic Compatibility (EMC), Safety and
Environmental certifications.
EMC Compliance
EC D
ECLARATION OF
C
ONFORMITY
- EMC
The probe meets intent of EC Directive 2004/108/EC for Electromagnetic Compatibility. Compliance
was demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 61326-1:2006, EN 61326-2-1:2006 EMC requirements for electrical equipment for measurement,
control, and laboratory use.