Teledyne LeCroy OE695G - Manual (Page 9)

Instruction Manual
922562-00 Rev A 3
Safety Information
Symbols
These symbols appear on the product or in this manual to alert you to important
information.
High Voltage, risk of electric shock.
CAUTION of potential damage to equipment, or WARNING of potential for bodily
injury. Attend to the accompanying information/product manual to protect
against personal injury or damage. Do not proceed until conditions are fully
understood and met.
DOUBLE INSULATION
PROTECTIVE (EARTH) TERMINAL
Precautions
Avoid personal injury, or damage to your accessory or any equipment connected
to it, by reviewing and complying with the following safety precautions:
Use only as intended. The accessory is intended to be used only with the
compatible Teledyne LeCroy instruments. Use of the accessory and/or the
equipment it is connected to in a manner other than specified may impair the
protection mechanisms.
Connect and disconnect properly. Avoid damage through excessive bending of
cables and other equipment.
Do not use in wet/damp or explosive atmospheres.
For indoor use only. The accessory is intended for indoor use and should be
operated in a clean, dry, environment.
Do not operate with suspected failures. Do not use the product if any part is
damaged. All maintenance should be referred to qualified service personnel.
Keep product surfaces clean and dry.
Completely assemble the measurement instrument before circuit/signal
contact. Connect accessory to the measurement instrument before connecting
the instrument test leads to a circuit/signal being tested.