Teledyne LeCroy Kibra DDR - Manual (Page 108)

Teledyne LeCroy Waveform View
106 Kibra DDR Protocol Analyzer User Manual
Figure 3.6: Zooming with Viewport Slider
3.2.4 Snap to Edge
If you have a marker or cursor and move it to within 10 pixels of a signal’s edge, a glyph is
displayed showing that it will be dropped on that edge of the signal when dropped. You
need to hover over that particular signal with the mouse to see it. Snap to Edge is
sensitive in horizontal and vertical positions.
3.2.5 Placing Cursors
To place a pair of cursors activate the Cursor button as shown below and click the left
mouse button to place the left (x) cursor and then click the right mouse button to place
the right (y) cursor any where in the Waveform view. See the pink X1/Y1 and X2/Y2
cursors below.
Figure 3.7: Placing Left and Right Cursors
Zooming with Viewport Slider Glyph showing signal edge
Press to activate placing cursor button
Left Cursor
Right Cursor
Cursor Button