Teledyne LeCroy Kibra DDR - Manual (Page 70)

Teledyne LeCroy Recording Options Setup
68 Kibra DDR Protocol Analyzer User Manual
Read/Write on Specific Address Trigger
If the System Address is defined in the Recording Options, the user can specify the target
address by entering the desired value in System Address. Ranks/Banks/ Row and Column
address are be filled automatically by the software when the user specifies the target
"System Address".
Note: The System Address field is disabled if there are no defined System Address patterns and it is
enabled when the user defines a System Address pattern.
Note: The trigger occurs according to the field values in Rows/Columns/Ranks and Banks. Hence, if
user modifies the value of these fields after specifying the target address, the changed mapped
values take effect.
Figure 2.37: Read/Write on Specific Address Trigger
Use System Address