Teledyne LeCroy SierraNet M168 User Manual Ver.1.40 - Manual (Page 194)

LeCroy Corporation InFusion Scenarios
192 SierraNet M168 Protocol Analyzer User Manual
4.5.3 Scenario Events
The following table describes the Presets that can be used as FCoE Events.
Note: You can have multiple Events and Actions in Global Rules and in each State.
TABLE 4.1: Simple Mode Events and their Descriptions (FCoE)
Event Description
User Patterns
Most Recent Lists the most recent Events.
New User Group Lists the new user groups.
Presets
Timers/External
Timer
The Event occurs when the timer expires.
Other Trigs Analyzer: the Event occurs when the Analyzer triggers.
External: the Event occurs when the external Trigger In is
asserted.
Basic
Ordered Set
Refer to section “Ordered Set” on page 113.
Basic Link Service Refer to section “Ethernet Basic” on page 87.
Link Control Frame Refer to section “Link Control Frame” on page 88 .
Link Speed The Event occurs when the link is at the specified speed.
Both Linkup The Event occurs when both ports are out of electric idle.
Dword Matcher Refer to section “Dword Matcher” on page 208 .
Training Sequence Inject Error on Control: Generates Manchester Coding
violation on Control field bits corresponding to the defined
mask: One means violation, and zero means no error.
Inject Error on Status: Generates Manchester Coding
violation on Status field bits corresponding to the defined
mask: One means violation, and zero means no error.
Frame Marker Error: Generates training sequence with an
invalid frame marker.
Recode Manchester Coding: Forces jammer to recalculate
Manchester Coding for each bit of training frame.
FCOE
FCP
FCP SCSI Command
Refer to section “Ethernet Basic” on page 87 .
FCP Frame Information
Unit Refer to section “FCP Patterns” on page 88 .
SCSI Command Status Refer to section “SCSI” on page 89 .
FCP Task Management Refer to section “FCP Patterns” on page 88 .
ELS