Teledyne LeCroy PETracer ProtoSync Software User Manual - Manual (Page 129)

PETracer Software User Manual Chapter 8: Reports and Tools
Teledyne LeCroy
123
The MBAR field in this dialog is required and editable. Make sure that the information
entered is correct. Click on any field and the description displays in the bottom read-only
box (see Figure 10.39 on page 215). Some important fields are described below:
• Device: There is only one device node, (support for multiple device trace decoding
will be available in a later release). If there is no device node, then the user can add
a device node by clicking the Add Device button.
• MBAR: The 64-bit main address bar (i.e. BAR1:BAR0). Without this value
decoding cannot be done. It should be in "0x" hex format.
• Ports: Under this node the user can add more missing nodes to decode the current
trace. Click the Add Port or Delete Port button to add or delete a port node. Enter
CLB, CLBU and FB, FBU address fields. The address is 32 bit and should be in "0x"
hex format. Please use the right value for size as it is an important attribute. Consult
the AHCI specifications for the correct value.