Teledyne LeCroy PETracer ProtoSync Software User Manual - Manual (Page 76)

Chapter 7: BitTracer Trace Files PETracer Software User Manual
70
Teledyne LeCroy
7.3 De-Skewing Data
By default, BitTracer recordings display captured data in a raw, time-skewed format,
across all lanes in both directions. Individual bytes are as they were captured on the
recorded link, before the receiver device on the link (or the receiver logic on the PETracer
analyzer) has performed lane-to-lane de-skew operations.
You can manually skew the captured data, left or right, in increments of one symbol time,
using the associated toolbar buttons.
You can automatically de-skew an entire lane direction. First, left-click on the direction in
the data window. Then right-click to display a popup menu. Then select Auto De-Skew.
You can de-skew only one direction for each right-click operation. To automatically
de-skew the opposite direction, first left-click on that direction in the data window.
7.4 Data Display Formats
To display traffic in K/D symbol (with Running Disparity indicated), scrambled,
descrambled, 10-bit, and Binary code formats:
• Use the toolbar.
• Right-click to display a menu.
• Place the cursor over any given byte to display all byte formats (including an LFSR
value) in pop-up list.
Note: Descrambled values can only be displayed after the first recorded skip ordered set.
Data prior to the skip is displayed in scrambled values, due to the unknown LFSR.
Note: For Binary Data Display Format, bits are shown in order of transmission on the bus.