Teledyne LeCroy PETracer ProtoSync Software User Manual - Manual (Page 132)

Chapter 8: Reports and Tools PETracer Software User Manual
126
Teledyne LeCroy
The address is 64-bit and should be in "0x" hex format. Please use the right value for
each size as it is an important attribute. Consult the NVMe specifications for the correct
value. Clicking the Re-Decode button erases the current configuration from this dialog
box and attempts to re-decode based on the information present in the open trace and/or
saved on the disk with the last decode.
Click button to decode the trace and select Tools > PCIe SSD Base Address
Mapping (see PCIe Address Configuration Dialog on previous page).
The two figures figure below show the BAR information for PQI and AHCI. If this
information is present in the trace then it is not editable, otherwise it can be edited.
Decoding is done only when configuration space and administration information is
available.