Teledyne LeCroy PETracer ML Analyzer and Exerciser User Manual - Manual (Page 48)

Chapter 3: Installation PETracer ML User Manual
40
Teledyne LeCroy
Add a PETracer ML to Host Emulation Test Setup
To add a PETracer ML to a Host Emulation setup:
Step 1 Attach connectors A and C to the Exerciser as described above.
Step 2 Attach connectors D to Port 1 and connector D to Port 2 on the
PETracer ML Analyzer.
Figure 3.6 PETracer ML Front Panel showing where Connectors B and D Attach
Final Steps: Connect USB Cable and Power On the Exerciser and
DUT
Step 1 Connect the provided USB cable between the UPAS 10K/PETrainer ML
and the host machine that runs the PETracer software.
Step 2 Power on the PCI Express system under test.
Step 3 Power on the UPAS 10K/Exerciser. The Exerciser's green power LED
lights, and the red status LED turns on for approximately 20 seconds
while the Exerciser performs self-diagnostics.