Teledyne LeCroy Sierra M124 User Manual - Manual (Page 262)

Teledyne LeCroy Creating a Sequence
260 Sierra M124 SAS/SATA Protocol Analyzer User Manual
The following table summarizes the examples that follow.
TABLE 4.6: Sequence Examples
4.10.1 Example 7: Creating Two Sequences and Global Rules
In this example, Global Rules substitute an Align (0) primitive for each of the following
received from the initiator: Align (1), Align (2), and Align (3). As a separate test operation,
two sequences determine the order in which each Identify Address frame is received
from initiator and target.
The following tables summarize the logic implemented by each of the sequences.
TABLE 4.7: Example 7: Logic of Sequence 0
TABLE 4.8: Example 7: Logic of Sequence 1
Example Description
7
Creating two sequences and Global Rules: This scenario has two
objectives that you implement with Global Rules and two sequences. 1)
You use Global Rules to replace any of three types of primitives. 2) You
use two sequences to detect the order in which a type of frame is
received from initiator and target.
8
Creating a sequence with many states #1: The objective of this scenario
is to detect an incorrect order of primitives and to cause the device to
beep when it happens. You implement this scenario with a single five‐
state sequence.
9
Creating a sequence with many states #2: This scenario is an
enhancement of example 8. In this scenario, the objective is to detect an
incorrect order of primitives, fix it, and cause the device to beep when
this happens. As with example 8, you implement this scenario with a
single five‐state sequence.
State Description
State 0 If Address Frame is detected from initiator, go to State 1;
otherwise, continue to check incoming frames (do not change state).
State 1 If next Address Frame detected is from target, beep 1 second.
State Description
State 0 If Address Frame is detected from target, go to State 1;
otherwise, continue to check incoming frames (do not change state).
State 1 If next Address Frame detected is from initiator, beep 2 seconds.