Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 60)

Protocol Analysis
50
Settings
Click the Settings tab to open the Project settings dialog box as shown in
Figure 30.
Figure 30 Project Settings Dialog Box
Analyzer Speed
The default is Auto Speed for automatic speed detection, however, you can
force the speed by choosing Full/Low or High for special testing needs.
Looping
You can specify the number of times to loop the command line(s) or you can
run them continually. You can set the number of times from 2 to a maximum of
1,048,575 times.
Clock
To specify a clock speed or an external clock, check the Full/Low Speed or
High Speed option buttons and the NonStandard check box. Then make a
Clocks choice. The available choices are four pre-set clock speeds and an
External clock, which must be connected to the Analyzer as described on
page 8.
Generate SOFs/Keep Alives when exerciser program ends
Check this box to keep device from suspending.
Data Blocks
If you require a new data block, click the button next to the
Data Block File dialog to open the data block definition dialog. Define a new
data block as described on page 86.