Teledyne LeCroy Signal Integrity Studio - Manual (Page 12)

Signal Integrity Studio
920134 RevA 12
Instructions Images
1 Example 1 (DUT: SPARQ demo board)
1. Go to File  Recall Setup… and touch Browse…
2. Select Signal Integrity Studio-Example1.lss
a. Click Recall Now: The user will see a dialog describing the example
b. After clicking OK to continue, the application will load the setup,
obtain a simulated waveform, and calculate the eye and jitter values
c. This example uses MyDUT-single-ended.s4p
2 Demo results
3 What is being shown  Top grids: S11 return loss and S13 insertion loss

Middle-left: Impedance profile and far-end crosstalk(FEXT)
 Middle-right: Jitter histogram, CDF, NQFit and bathtub curve.
 Lower-left: Eye diagram after emulating the channel using a simulated 6Gbps PRBS7 pattern

Lower-right: Zoom the simulated waveform (white) and waveform after channel emulation (red)