Teledyne LeCroy Signal Integrity Studio - Manual (Page 8)

Signal Integrity Studio
920134 RevA 8
B. Configure the Simulator
Select Simulator... from the Analysis menu:
1. Go to the SimC1 tab.
2. Select the DataJit signal type.
3. Click the Jitter Settings button to open the Data/Jitter configuration window.
4. Configure the Data/Jitter simulator as desired and then click Close. For more details on configuring this screen, see the topic on
Data/Jitter Configuration.
Note: The Frequency setting configures the bitrate for NRZ type.
5. In the Simulator tab, change the trigger mode to "Single" to generate a simulated waveform. The waveforms generated are named
SimC1P and SimC1M. The waveforms can also be viewed by checking the View (+) and View (-) checkboxes in the SimC1 tab.