Teledyne LeCroy Serial Data Debug Solutions - Manual (Page 152)

Serial Data Debug Solutions
152 919586 RevA
Enabling Tests
Enable/disable a test by either marking/unmarking its respective checkbox from the summary area...
OR
Go directly to its corresponding test dialog and enable/disable it from there.
Official MIPI M-PHY Test Algorithms
Specific test information is maintained by the MIPI Alliance and can be found at www.mipi.org .
Note: Registration with the Alliance is required to access the document.
A DDITIONAL C ONTROLS
Note: Some of the controls on this dialog are enabled/disabled based on Mode, Probing, and Input Selection
control choices.
The far right of the MIPI M-PHY dialog includes additional controls for CDR, Bit Rate, Find Bit Rate, and
SDA Menu.... As controls are used, MIPI M-PHY processes the information and responds in real time.