Teledyne LeCroy Serial Data Debug Solutions - Manual (Page 153)

Operator's Manual
919586 RevA 153

Touch the CDR control and select from Linear, Filtered, and Short-Term choices.

The next two controls allow you to either enter a specific Bit Rate, or have MIPI M-PHY find your signal's
bitrate.

Finally a convenient SDA Menu... button is available for quick access to the main SDA dialog.
T HE V IEWS D IALOG (I NCLUDING THE S HOW E YE C ONTROL )
Touch the Views tab and the Views dialog is shown.
Note: Some of the controls on this dialog are enabled/disabled based on Mode, Probing, and Input Selection
control choices.
This dialog includes controls for Data Diff, Eye, Mask Mode, CDR, Common-mode, PSD, CM Load, Fall, and Rise.
As controls are used, MIPI M-PHY processes the information and responds in real time.
The Show Eye Control
Marking this checkbox shows the eye diagram trace on the display area and includes a corresponding trace
descriptor label.