Waterstone UNDER SINK SYSTEMS 4500 - Manual (Page 2)

1 2 3 4
Turn off water supply. Observe all local
plumbing codes.
Inspect waste and water
supplies for signs of damage.
Replace as necessary.
DO NOT use petroleum
based products on this
faucet.
REQUIRED TOOLS: PARTS INCLUDED:
2. Phillips Screwdriver 1. Adjustable Wrench
4500
PRV 516380
5/16” TO 3/8”
CONNECTOR 141400
1/4” TO 1/4”
CONNECTOR
3 LINE VENTED FAUCET
Connection to a non-vented faucet WILL DAMAGE THE TANK and void the warranty.
A kinked tank outlet tube or debris in the faucet obstructing the free flow of water from the
tank will subject the tank to pressures exceeding its design limits and cause the tank to leak.
The included Pressure Regulating Valve (PRV) must be installed with this Hot Tank to prevent
damage from excessive pressure and maintain the warranty.
WARNING - USE OF AN IN-LINE INSTALLATION OF A WATER CHILLER WITH A
WATERSTONE FAUCET OF ANY KIND WILL VOID OUR WARRANTY.
Since 2005, Waterstone has continued to advise all of our customers against the installation of any brand of
in-line water chiller unit with our faucets. Compressor style chiller units have been proven to arbitrarily exceed
the standard household in line pressure ratings causing the faucet inlet connection line to burst and create the potential for water damage
claims in the field.
Waterstone can not and will not be held liable for damages created by a use for which our products were not designed. Waterstone will
only recommend the installation of a water chiller in the vented side (in place of a hot tank) with one of our Hot or Hot & Cold Filtration
faucet models.
BEFORE YOU BEGIN YOUR INSTALLATION:
I N S T A L L A T I O N G U I D E
WARNING!
THE WATERSTONE #5000 HOT TANK IS DESIGNED FOR USE WITH
A 3 LINE VENTED FAUCET ONLY.