Waterstone UNDER SINK SYSTEMS 4500 - Manual (Page 4)

Q
CABINET WALL
HOT TANK UNIT
(SIDE VIEW)
1.
12”
2. 3. 4.
V
R
S
U
T
Slide nut (R) onto
center Hot Tank tube
(S), threads up. Slide
on tapered collar (T).
Slide on 2 orange
O-rings (U). Position
stack of components on tube so that
O-rings are even with top tube. Hold nut
in place and thread connector body (V)
onto nut until snug.
Find a location under your sink that has access
to an electrical outlet and close enough to
reach faucet tube leads without kinking. For the
tank to operate properly, it cannot be installed
beyond the reach of the factory tubing.
Install hanging bracket (Q) to
cabinet wall. Make sure top
edge of bracket is at least 12”
from bottom of cabinet.
Mount tank on hanging
bracket as shown.
HOT TANK INSTALLATION
CHOOSE TANK LOCATION
INSTALL BRACKET
MOUNT TANK
CONNECTOR INSTALLATION
WARNING! DO NOT PLUG IN THE
HOT TANK UNTIL IT IS FILLED WITH
WATER. HEATING THE TANK WHILE
EMPTY WILL DAMAGE UNIT