Waterstone UNDER SINK SYSTEMS 4500 - Manual (Page 5)

5. 6. 7.
7. 9.
Y
X
W
AA
BB
Z
CC
DD
SIDE VIEW
OFF
LOW
HIGH
10.
MY TANK WILL NOT HEAT WATER
The model 5000 Hot Tank will take between 10 and 20 minutes to heat water to the setting specified on the temperature control dial. If after
that time your tank is not heating water, make sure that it is plugged into a 110v electrical outlet. Keep in mind that sometimes the outlets
under your sink are set up to be switched on with the garbage disposal. A good way to test the functionality of your outlet is to plug something
else, like a lamp, into that outlet. If you have confirmed that your outlet is functioning properly and your tank still does not heat water after 20
minutes, please call Technical Support at 888-304-0660.
Continued on back panel...
WATERSTONE MODEL 5000 BASIC TROUBLESHOOTING TIPS
Connect 1/4” quick connect fitting (W)
to hot tank inlet (X). Connect 1/4” red
tube (Y) to connect fitting. Push until
secure.
Turn water suppy back on. Turn on hot water until water
flows freely from faucet. This
means the Hot Tank is full. Plug in Hot Tank and turn temperature control dial to
desired setting.
Connect 1/4” blue tube (BB) to PRV
valve (CC). Connect 1/4” supply tube
(not provided) from PRV valve to water
supply (DD). Connect 5/16” clear tube (Z) to connect
fitting (AA). Push until secure.