WolfVision VZ-15b User Manual - Manual (Page 23)

Symptoms: Check points:
The lightfield on the working surface is much
larger than the recorded area. Please note that the lightfield has to be a little bit larger than the recorded
area, otherwise it would not fit in all positions (on the working surface).
However if it is much too big check the following:
- First check if it is possible to adjust your monitor. Many monitors do not
display the whole picture. Some show more of the right side, some more of
the left side etc. Check if there is an UNDERSCAN function - with this
function you can display 100% of the Visualizer picture.
- If you are working with a projector (CTR) check the "blanking" of the
projector
- If you are sure that the lightfield is still much larger than the recorded area
and it is not due to a wrong adjustment of your monitor or your projector,
consult your WolfVision dealer. The size of the lightfield can be adjusted
electronically using a special WolfVision service software.
Infrared remote control does not work - Change the battery! (see page 13)
- If the unit cannot be controlled with the infrared remote control even from
a close distance and with a new battery it may be due to a wrong frequency
(see page 13).
Color bars appear on monitor (VZ-35b and VZ-45b) - Press the BARS key of the camera control panel (#12)
VZ-45b: Two horizontally compressed pictures
apperar side by side on the monitor - The monitor can not display a S-VGA-signal. Use a multiscan-monitor
instead
23