IEI Integration PCIE-Q350 v1.00 - Manual (Page 157)

PCIE-Q350 PICMG 1.3 CPU Card
Page 135
Use the Remote Access option to enable or disable access to the remote functionalities
of the system.
Disabled D EFAULT Remote access is disabled.
Enabled Remote access configuration options shown below
appear:
Serial Port Number
Serial Port Mode
Flow Control
Redirection after BIOS POST
Terminal Type
VT-UTF8 Combo Key Support
Sredir Memory Display Delay
These configuration options are discussed below.
Serial Port Number [COM1]
Use the Serial Port Number option to select the serial port used for remote access.
COM1 D EFAULT System is remotely accessed through COM1
COM2 System is remotely accessed through COM2
NOTE: Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Base Address, IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.