IEI Integration PCIE-Q870-i2 - Manual (Page 76)

PCIE-Q870-i2 PICMG 1.3 CPU Card
Page 59
Figure 4-12: iRIS Module Installation
Step 1: Locate the iRIS module slot. Place the PCIE-Q870-i2 on an anti-static pad.
Step 2: Align the iRIS-2400 module with the iRIS module slot. Align the notch on the
module with the notch on the iRIS module slot.
Step 3: Insert the iRIS-2400 module. Push the module in at a 20º angle (Figure 4-12).
Step 4: Seat the iRIS-2400 module. Gently push downwards and the arms clip into
place (Figure 4-12). Step 0:
NOTE:
After installing the iRIS-2400 module, use LAN2 port to establish a
network connection. Please refer to Section 4.8 for IPMI setup
procedures.
4.5.3 SATA Drive Connection
The PCIE-Q870-i2 is shipped with two SATA drive cables. To connect the SATA drives to
the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.