IEI Integration HYPER-KBN - Manual (Page 52)

HYPER-KBN
P a g e 40
S te p 3: Connect the audio devices. Connect speakers to the line-out audio jack.
Connect the output of an audio device to the line-in audio jack. Connect a
microphone to the mic-in audio jack. S te p 0:
4.4.2 S ATA Drive Co n n e c tio n
The HYPER-KBN is shipped with a SATA drive cable. To connect the SATA drive to the
connector, please follow the steps below.
S te p 1: Locate the SATA connector and the SATA power connector. The locations of
the connectors are shown in Chapter 3.
S te p 2: Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector and the SATA power connector. See Figure 4-3.
Figure 4-3: SATA Drive Cable Connection
S te p 3: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-3.