IEI Integration HYPER-KBN - Manual (Page 55)

HYPER-KBN
P a g e 43
Figure 4-5: DVI Connector
S te p 4: Secure the connector. Secure the DVI connector from the digital display device
to the external interface by tightening the two retention screws on either side of
the connector.
4.5.2 LAN Co n n e c tio n
There is one external RJ-45 LAN connector on the external peripheral interface panel. The
RJ-45 connector enables connection to an external network. To connect a LAN cable with
an RJ-45 connector, please follow the instructions below.
S te p 1: Locate the RJ-45 connector. The location of the LAN connector is shown in
Chapter 3.
S te p 2: Align the connector. Align the RJ-45 connector on the LAN cable with the
RJ-45 connectors on the HYPER-KBN. See Figure 4-6.