IEI Integration KINO-DH810 - Manual (Page 69)

KINO-DH810
P a g e 57
Figure 4-10: LAN Connection
S te p 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the on-board RJ-45 connector.
4.5.4 S e ria l De vic e Co n n e c tio n
The KINO-DH810 has two single female DB-9 connectors on the external peripheral
interface panel for a serial device. Follow the steps below to connect a serial device to the
KINO-DH810.
S te p 1: Locate the DB-9 connector. The locations of the DB-9 connectors are shown
in Chapter 3.
S te p 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See Figure 4-11.