6 usb device connection, Figure 4-21: serial device connector – IEI Integration IMB-Q354 v1.20 User Manual
Page 82
Advertising
IMB-Q354 microATX Motherboard
Page 68
Figure 4-21: Serial Device Connector
Step 3:
Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0:
4.8.6 USB Device Connection
There are four external USB 2.0 connectors. To connect a USB 2.0 or USB 1.1 device,
please follow the instructions below.
Step 1:
Located the USB connectors. The locations of the USB connectors are shown
in Chapter 4.
Step 2:
Align the connectors. Align the USB device connector with one of the
connectors on the IMB-Q354. See Figure 4-22.
Advertising