IEI Integration IMB-Q354 v1.20 - Manual (Page 92)

IMB-Q354 microATX Motherboard
Page 78
SATA#1 Configuration [Enhanced]
Use the SATA#n BIOS option to enable the n th SATA drive port.
Disabled The n
th
SATA drive port is disabled
Enhanced D EFAULT The n
th
SATA drive port is activated
Configure SATA as [IDE]
Use the Configure SATA as option to configure SATA devices as normal IDE devices.
IDE D EFAULT Configures SATA devices as normal IDE device.
RAID Configures SATA devices as RAID device.
AHCI Configures SATA devices as AHCI device.
IDE Master and IDE Slave
When entering setup, BIOS auto detects the presence of IDE devices. BIOS displays the
status of the auto detected IDE devices. The following IDE devices are detected and are
shown in the IDE Configuration menu:
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave
Third IDE Master
Fourth IDE Master
The IDE Configuration menu (BIOS Menu 4) allows changes to the configurations for the
IDE devices installed in the system. If an IDE device is detected, and one of the above
listed four BIOS configuration options are selected, the IDE configuration options shown in
Section 5.3.2.1 appear.
5.3.2.1 IDE Master, IDE Slave
Use the IDE Master and IDE Slave configuration menu to view both primary and
secondary IDE device details and configure the IDE devices connected to the system.