IEI Integration IMB-Q770 - Manual (Page 76)

IMB-Q770 Mic ro -ATX Mo th e rb o a rd
P a g e 60
Figure 4-9: Clear BIOS Jumper Location
4.4 In te rn a l P e rip h e ra l De vic e Co n n e c tio n s
This section outlines the installation of peripheral devices to the onboard connectors.
4.4.1 S ATA Drive Co n n e c tio n
The IMB-Q770 is shipped with four SATA drive cables. To connect the SATA drives to the
connectors, please follow the steps below.
S te p 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
S te p 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-10.