IEI Integration IMB-Q770 - Manual (Page 80)

IMB-Q770 Mic ro -ATX Mo th e rb o a rd
P a g e 64
S te p 2: Align the DVI-D connector. Align the male DVI-D connector on the digital
display device cable with the female DVI-D connector on the external peripheral
interface.
S te p 3: Insert the DVI-D connector . Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the IMB-Q770. See Figure 4-13.
Figure 4-13: DVI Connector
Secure the connector. Secure the DVI-D connector from the digital display device to the
external interface by tightening the two retention screws on either side of the connector.
S te p 0:
4.5.3 HDMI Co n n e c tio n
The HDMI connector transmits a digital signal to compatible HDMI display devices such
as a TV or computer screen. To connect the HDMI cable to the IMB-Q770, follow the steps
below.
S te p 1: Locate the HDMI connector. The location is shown in a previous section.