IEI Integration IMB-C2160 - Manual (Page 73)

IMB-C2160 Mic ro -ATX Mo th e rb o a rd
P a g e 58
Setting Description
Open AT Mode
Table 4-2: AT/ATX Power Select Jumper Settings
Figure 4-9: AT/ATX Power Select Jumper Location
4.4.2 Cle a r CMOS J u m p e r
J u m p e r La b e l: J _CMOS 2
J u m p e r Typ e : 3-pin header
J u m p e r S e ttin g s : See Table 4-3
J u m p e r Lo c a tio n : See Figure 4-10
If the IMB-C2160 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
  Enter the correct CMOS setting
  Load Optimal Defaults
  Load Failsafe Defaults.