5 internal peripheral device connections, 1 sata drive connection, Nternal – IEI Integration IMB-C2160 User Manual
Page 75: Eripheral, Evice, Onnections, Figure 4-11: wol mode select jumper location
IMB-C2160 Mic ro -ATX Mo th e rb o a rd
P a g e 60
The location of the WOL mode select jumper is shown in Figure 4-10 below.
Figure 4-11: WOL Mode Select Jumper Location
4.5 In te rn a l P e rip h e ra l De vic e Co n n e c tio n s
This section outlines the installation of peripheral devices to the onboard connectors.
4.5.1 S ATA Drive Co n n e c tio n
The IMB-C2160 is shipped with four SATA drive cables. To connect the SATA drives to
the connectors, please follow the steps below.
S te p 1:
Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
S te p 2:
Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-12.