IEI Integration IMBA-Q454 v1.00 - Manual (Page 77)

IMBA-Q454-R10 User Manual
Page 77
Figure 4-11: Single RS-232 Cable Installation
Step 3: Secure the bracket. The single RS-232 connector has one D-sub 9 male
connector secured to a bracket. To secure the bracket to the chassis please
refer to the reference material that came with the chassis Step 0:
4.5.4 SATA Drive Connection
The IMBA-Q454-R10 is shipped with two SATA drive cables and one SATA drive power
cable. To connect the SATA drives to the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See
8
Figure 4-12.