IEI Integration IMBA-Q454 v1.00 - Manual (Page 85)

IMBA-Q454-R10 User Manual
Page 85
Figure 4-18: Parallel Device Connector
Step 3: Secure the connector. Secure the DB-25 connector to the external interface by
tightening the two retention screws on either side of the connector. Step 0:
4.6.4 Serial Device
The IMBA-Q454-R10 has a single female DB-9 connector on the external peripheral
interface panel for a serial device. Follow the steps below to connect a serial device to the
IMBA-Q454-R10.
Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in
Chapter 3.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See
8
Figure 4-19.