IEI Integration IMBA-C2260-i2 - Manual (Page 80)

IMBA-C2260-i2 ATX Motherboard
Page 63
4.3 iRIS Module Installation
WARNING:
The iRIS module slot is designed to install the iRIS-2400 module only.
DO NOT install other modules into the iRIS module slot. Doing so may
cause damage to the IMBA-C2260-i2.
To install the iRIS-2400 module, please follow the steps below and refer to Figure 4-7.
Figure 4-7: iRIS Module Installation
Step 1: Locate the iRIS module slot. See Figure 3-16.
Step 2: Open the socket handles. Open the two handles outwards as far as they can.
See Figure 4-7.
Step 3: Align the iRIS-2400 module with the socket. Align the iRIS-2400 module so
the notch on the module lines up with the notch on the socket. See Figure 4-7.
Step 4: Insert the iRIS-2400 module. Once aligned, press down until the iRIS-2400
module is properly seated. Clip the two handles into place. See Figure 4-7.