IEI Integration IMBA-C2260-i2 - Manual (Page 81)

IMBA-C2260-i2 ATX Motherboard
Page 64
Step 5: Removing the iRIS-2400 module. To remove the iRIS-2400 module, push both
handles outward. The module is ejected by a mechanism in the socket. Step 0:
NOTE:
After installing the iRIS-2400 module, use LAN1_USB2 port to
establish a network connection. Please refer to Section 4.9 for IPMI
setup procedures.
4.4 mSATA Card Installation
To install an mSATA card, please follow the steps below.
Step 1: Locate the mSATA card slot. The location of the mSATA card slot is shown in
Chapter 3.
Step 2: Remove the retention screws. Remove the two retention screws secured on
the motherboard as shown in
9
Figure 4-8.
Figure 4-8: Remove the Retention Screws for the mSATA Card
Step 3: Insert into the socket at an angle. Line up the notch on the card with the notch
on the connector. Slide the mSATA card into the socket at an angle of about 20º
(
9
Figure 4-9).