IEI Integration NANO-945GSE v1.01 - Manual (Page 110)

NANO-945GSE EPIC Motherboard
Page 90
HDTV out cable
44-pin 2.5” IDE cable
44-pin 2.5”/3.5” IDE cable
SATA power cable
5.1 channel audio kit
7.1 channel audio kit
5.7.2 AT Power Connection
Follow the instructions below to connect the NANO-945GSE to an AT power supply.
WARNING:
Disconnect the power supply power cord from its AC power source to
prevent a sudden power surge to the NANO-945GSE.
Step 1: Locate the power cable. The power cable is shown in the packing list in
Chapter 3.
Step 2: Connect the Power Cable to the Motherboard. Connect the 4-pin (2x2) Molex
type power cable connector to the AT power connector on the motherboard. See
904H
Figure 5-11.